Cavitation in fluid mechanics and engineering normally is the phenomenon in which the static pressure of a liquid reduces to below the liquid's vapor pressure, leading to the formation of small vapor-filled cavities in the liquid. When subjected to higher pressure, these cavities, called "bubbles" or "voids", collapse and can generate shock waves that may damage machinery. As a concrete propeller example: The pressure on the suction side of the propeller blades can be very low and when the pressure falls to that of the vapour pressure of the working liquid, cavities filled with gas vapour can form. The process of the formation of these cavities is referred to as cavitation. If the cavities move into the regions of higher pressure (lower velocity), they will implode or collapse. These shock waves are strong when they are very close to the imploded bubble, but rapidly weaken as they propagate away from the implosion. Cavitation collapse is therefore a significant cause of wear in some engineering contexts. Collapsing voids that implode near to a hard surface cause cyclic stress through repeated implosion. This results in surface fatigue of the material, causing a type of damage also called "cavitation damage" or "cavitation erosion". The most common examples of this kind of wear are to pump impellers, and pipe bends where a sudden change in the direction of fast moving liquid occurs.
Cavitation is usually divided into two classes of behavior. Inertial (or transient) cavitation is the process in which a void or bubble in a liquid rapidly collapses, producing a shock wave. It occurs in nature in the strikes of mantis shrimp and pistol shrimp, as well as in the vascular tissues of plants. In manufactured objects, it can occur in control valves, pumps, propellers and impellers.Non-inertial cavitation is the process in which a bubble in a fluid is forced to oscillate in size or shape due to some form of energy input, such as an acoustic field. The gas in the bubble may contain a portion of a different gas than the vapor phase of the liquid. Such cavitation is often employed in ultrasonic cleaning baths and can also be observed in pumps, propellers, etc.