Firing pin in the context of Hand grenade

A grenade is a small explosive weapon typically thrown by hand (also called hand grenade), but can also refer to a shell (explosive projectile) shot from the muzzle of a rifle (as a rifle grenade) or a grenade launcher. A modern hand grenade generally consists of an explosive charge ("filler"), a detonator mechanism, an internal striker to trigger the detonator, an arming safety secured by a transport safety. The user removes the transport safety before throwing, and once the grenade leaves the hand the arming safety gets released, allowing the striker to trigger a primer that ignites a fuze (sometimes called the delay element), which burns down to the detonator and explodes the main charge.

Grenades work by dispersing fragments (fragmentation grenades), shockwaves (high-explosive and stun grenades), chemical aerosols (smoke, gas and chemical grenades), fire (incendiary grenades) or a jet of molten metal (anti-tank grenades). Their outer casings, generally made of a hard synthetic material or steel, are designed to rupture and fragment on detonation, sending out numerous fragments (shards and splinters) as fast-flying projectiles. In modern grenades, a pre-formed fragmentation matrix inside the grenade is commonly used, which may be spherical, cuboid, wire or notched wire. Most anti-personnel (AP) grenades are designed to detonate either after a time delay or on impact.

A repeating rifle is a single-barreled rifle capable of repeated discharges between each ammunition reload. This is typically achieved by having multiple cartridges stored in a magazine (within or attached to the rifle) and then fed individually into the chamber by a reciprocating bolt, via either a manual or automatic action mechanism, while the act of chambering the round typically also recocks the hammer/striker for the following shot. In common usage, the term "repeating rifle" most often refers specifically to manual repeating rifles (e.g. lever-action, pump-action, bolt-action, etc.), as opposed to self-loading rifles, which use the recoil, gas, or blowback of the previous shot to cycle the action and load the next round, even though all self-loading firearms are technically a subcategory of repeating firearms.

Repeating rifles were a significant advance over the preceding single-shot, breechloading rifles when used for military combat, as they allowed a much greater rate of fire. The repeating Henry rifle was used by the infantry and Spencer rifle was used by the cavalry during the American Civil War and the subsequent American Indian Wars, and the first repeating air rifle to see military service was the Windbüchse rifle.

A semi-automatic pistol (also called a self-loading pistol, autopistol, or autoloading pistol) is a repeating handgun that automatically ejects and loads cartridges in its chamber after every shot fired, but only one round of ammunition is fired each time the trigger is pulled. The pistol's fire control group disconnects the trigger mechanism from the firing pin/striker until the trigger has been released and reset manually, unlike the self-cycled firing mechanism in fully automatic pistols.

A semi-automatic pistol recycles part of the energy released by the propellant combustion to move its bolt, which is usually housed inside the slide. After a round of ammunition is fired, the spent cartridge casing is extracted and ejected as the slide/bolt moves rearwards under recoil, the hammer/striker is cocked by the slide/bolt movement, and a new round from the magazine is pushed into the chamber when the slide/bolt returns forward under spring tension. This sets up the following shot (i.e. "in battery"), which is fired as soon as the trigger is pulled again. Most pistols use a short recoil operation to perform this, but some pistols use simple blowback or gas operation mechanisms.

In firearm designs, the term single-shot refers to guns that can hold only a single round of ammunition inside and thus must be reloaded manually after every shot. Compared to multi-shot repeating firearms ("repeaters"), single-shot designs have no moving parts other than the trigger, hammer/firing pin or frizzen, and therefore do not need a sizable receiver behind the barrel to accommodate a moving action, making them far less complex and more robust than revolvers or magazine/belt-fed firearms, but also with much slower rates of fire.

The history of firearms began with muzzleloading single-shot firearms such as the hand cannon and arquebus, then multi-barreled designs such as the derringer appeared, and eventually many centuries passed before breechloading repeating firearms became commonplace. Although largely disappeared from military usage due to insufficient firepower, single-shot firearms are still produced by many manufacturers in both muzzleloading and cartridge-firing varieties, from zip guns and ultra-concealable pocket pistols to the highest-quality hunting and match rifles.

A lever action is a type of action for repeating firearms that uses a manually operated cocking handle located around the trigger guard area (often incorporating it) that pivots forward to move the bolt via internal linkages, which will feed and extract cartridges into and out of the chamber, and cock the firing pin mechanism. This contrasts to other type of repeating actions such as the bolt-action, pump-action, semi-automatic, fully automatic, and/or burst mode actions. A firearm using this operating mechanism is colloquially referred to as a levergun.

Most lever-action firearms are rifles, but some lever-action shotguns and a few pistols have been made. The Winchester Model 1873 rifle is one of the most famous lever-action firearms, but many manufacturers (notably Henry Repeating Arms and Marlin Firearms) also produce lever-action rifles. Colt produced the 6403 lever-action Colt-Burgess rifles from 1883 until 1885 and Mossberg formerly produced the Model 464 rifle.

Pump action is a type of manual firearm action that is operated by moving a sliding handguard on the gun's forestock. After shooting a round, the sliding handguard is pulled rearward to eject any expended cartridge and typically to cock the hammer or striker, and then pushed forward to load a new cartridge into the chamber. Most pump-action firearms use an integral tubular magazine, although others use detachable box magazines. Pump-action mechanisms are typically found in shotguns, although they also may be found in rifles, grenade launchers, and other types of firearms. A firearm using this operating mechanism is colloquially referred to as a pumpgun.

Because the forend (handguard) is usually manipulated with the support hand, a pump-action firearm can fire additional shots much faster than a bolt-action and somewhat faster than a lever-action, as it does not require the trigger hand to be removed from the trigger while reloading. Also because the action is cycled in a linear fashion, it creates less torque that can tilt and throw the gun off aim when repeat-firing rapidly.

A bolt is the part of a repeating, breechloading firearm that blocks the rear opening (breech) of the barrel chamber while the propellant burns, and moves back and forward to facilitate loading/unloading of cartridges from the magazine. The firing pin and extractor are often integral parts of the bolt. The terms "breechblock" and "bolt" are often used interchangeably or without a clear distinction, though usually, a bolt is a type of breechblock that has a nominally circular cross-section.

In most automatic firearms that use delayed blowback, recoil, or gas operation, the bolt itself is housed within the larger bolt carrier group (BCG), which contains additional parts that receives rearward push from a gas tube (direct impingement) or a gas piston (short-stroke or long-stroke piston) system. The slide of a self-loading pistol contains the same components and serves similar functions.

The 1931 Fabrique Nationale (FN) Baby Browning is a small blowback-operated semi-automatic pistol designed by Belgium-born Dieudonné Saive and based on John Browning's 1908 Vest Pocket pistol. Chambered in .25 ACP (6.35×15 mm), the pistol accepts a six-round magazine and features a manual safety. It uses a striker-fired, single action, blowback mechanism.

The lock of a firearm is the mechanism used to initiate firing. It is generally used as a historical term, referring to such mechanisms used in muzzle-loading and early breech-loading firearms, as modern firearms uniformly fire by use of a firing pin to strike the rear of a cartridge. Side-lock refers to the type of construction, in which the individual components of the mechanism are mounted either side of a single plate. The assembly is then mounted to the stock on the side of the firearm. In modern firearm designs, the mechanism to initiate firing is generally constructed within the frame or receiver of the firearm and is referred to as the firing or trigger mechanism.

The hammer is a part of a firearm that is used to strike the percussion cap/primer, or a separate firing pin, to ignite the propellant and fire the projectile. It is so called because it resembles a hammer in both form and function. The hammer itself is a metal piece that forcefully rotates about a pivot point.

The term tumbler can refer to a part of the hammer or a part mechanically attached to the pivot-point of the hammer, depending on the particular firearm under discussion (see half-cock). According to one source the term tumbler is synonymous with hammer.

An automatic firearm or fully automatic firearm (to avoid confusion with semi-automatic firearms) is a self-loading firearm that continuously chambers and fires rounds when the trigger mechanism is actuated. The action of an automatic firearm is capable of harvesting the excess energy released from a previous discharge to feed a new ammunition round into the chamber, and then igniting the propellant and discharging the projectile (either bullet, shot, or slug) by delivering a hammer or striker impact on the primer.

If both the feeding and ignition procedures are automatically cycled, the weapon will be considered "fully automatic" and will fire continuously as long as the trigger is kept depressed and the ammunition feeding (either from a magazine or a belt) remains available. In contrast, a firearm is considered "semi-automatic" if it only automatically cycles to chamber new rounds (i.e. self-loading), but does not automatically fire off the shot unless the user manually resets (usually by releasing) and re-actuates the trigger, so only one round gets discharged with each individual trigger-pull. A burst-fire firearm is an "in-between" of fully and semi-automatic firearms, firing a brief continuous "burst" of multiple rounds with each trigger-pull, but then will require a manual re-actuation of the trigger to fire another burst.

A trigger is a mechanism that actuates the function of a ranged weapon such as a firearm, airgun, crossbow, or speargun. The word may also be used to describe a switch that initiates the operation of other non-shooting devices such as a trap, a power tool, or a quick release. A small amount of energy applied to the trigger leads to the release of much more energy.

Most triggers use a small flat or slightly curved lever (called the trigger blade) depressed by the index finger, but some weapons such as the M2 Browning machine gun or the Iron Horse TOR ("thumb-operated receiver") use a push-button-like thumb-actuated trigger design, and others like the Springfield Armory M6 Scout use a squeeze-bar trigger similar to the "ticklers" on medieval European crossbows. Although the word "trigger" technically implies the entire mechanism (known as the trigger group), colloquially it is usually used to refer specifically to the trigger blade.