Firing pin in the context of "Grenades"

A repeating rifle is a single-barreled rifle capable of repeated discharges between each ammunition reload. This is typically achieved by having multiple cartridges stored in a magazine (within or attached to the rifle) and then fed individually into the chamber by a reciprocating bolt, via either a manual or automatic action mechanism, while the act of chambering the round typically also recocks the hammer/striker for the following shot. In common usage, the term "repeating rifle" most often refers specifically to manual repeating rifles (e.g. lever-action, pump-action, bolt-action, etc.), as opposed to self-loading rifles, which use the recoil, gas, or blowback of the previous shot to cycle the action and load the next round, even though all self-loading firearms are technically a subcategory of repeating firearms.

Repeating rifles were a significant advance over the preceding single-shot, breechloading rifles when used for military combat, as they allowed a much greater rate of fire. The repeating Henry rifle was used by the infantry and Spencer rifle was used by the cavalry during the American Civil War and the subsequent American Indian Wars, and the first repeating air rifle to see military service was the Windbüchse rifle.

A semi-automatic pistol (also called a self-loading pistol, autopistol, or autoloading pistol) is a repeating handgun that automatically ejects and loads cartridges in its chamber after every shot fired, but only one round of ammunition is fired each time the trigger is pulled. The pistol's fire control group disconnects the trigger mechanism from the firing pin/striker until the trigger has been released and reset manually, unlike the self-cycled firing mechanism in fully automatic pistols.

A semi-automatic pistol recycles part of the energy released by the propellant combustion to move its bolt, which is usually housed inside the slide. After a round of ammunition is fired, the spent cartridge casing is extracted and ejected as the slide/bolt moves rearwards under recoil, the hammer/striker is cocked by the slide/bolt movement, and a new round from the magazine is pushed into the chamber when the slide/bolt returns forward under spring tension. This sets up the following shot (i.e. "in battery"), which is fired as soon as the trigger is pulled again. Most pistols use a short recoil operation to perform this, but some pistols use simple blowback or gas operation mechanisms.

In firearm designs, the term single-shot refers to guns that can hold only a single round of ammunition inside and thus must be reloaded manually after every shot. Compared to multi-shot repeating firearms ("repeaters"), single-shot designs have no moving parts other than the trigger, hammer/firing pin or frizzen, and therefore do not need a sizable receiver behind the barrel to accommodate a moving action, making them far less complex and more robust than revolvers or magazine/belt-fed firearms, but also with much slower rates of fire.

The history of firearms began with muzzleloading single-shot firearms such as the hand cannon and arquebus, then multi-barreled designs such as the derringer appeared, and eventually many centuries passed before breechloading repeating firearms became commonplace. Although largely disappeared from military usage due to insufficient firepower, single-shot firearms are still produced by many manufacturers in both muzzleloading and cartridge-firing varieties, from zip guns and ultra-concealable pocket pistols to the highest-quality hunting and match rifles.

A lever action is a type of action for repeating firearms that uses a manually operated cocking handle located around the trigger guard area (often incorporating it) that pivots forward to move the bolt via internal linkages, which will feed and extract cartridges into and out of the chamber, and cock the firing pin mechanism. This contrasts to other type of repeating actions such as the bolt-action, pump-action, semi-automatic, fully automatic, and/or burst mode actions. A firearm using this operating mechanism is colloquially referred to as a levergun.

Most lever-action firearms are rifles, but some lever-action shotguns and a few pistols have been made. The Winchester Model 1873 rifle is one of the most famous lever-action firearms, but many manufacturers (notably Henry Repeating Arms and Marlin Firearms) also produce lever-action rifles. Colt produced the 6403 lever-action Colt-Burgess rifles from 1883 until 1885 and Mossberg formerly produced the Model 464 rifle.

Pump action is a type of manual firearm action that is operated by moving a sliding handguard on the gun's forestock. After shooting a round, the sliding handguard is pulled rearward to eject any expended cartridge and typically to cock the hammer or striker, and then pushed forward to load a new cartridge into the chamber. Most pump-action firearms use an integral tubular magazine, although others use detachable box magazines. Pump-action mechanisms are typically found in shotguns, although they also may be found in rifles, grenade launchers, and other types of firearms. A firearm using this operating mechanism is colloquially referred to as a pumpgun.

Because the forend (handguard) is usually manipulated with the support hand, a pump-action firearm can fire additional shots much faster than a bolt-action and somewhat faster than a lever-action, as it does not require the trigger hand to be removed from the trigger while reloading. Also because the action is cycled in a linear fashion, it creates less torque that can tilt and throw the gun off aim when repeat-firing rapidly.