Elevators are flight control surfaces, usually at the rear of an aircraft, which control the aircraft's pitch, and therefore the angle of attack and the lift of the wing. The elevators are usually hinged to the tailplane or horizontal stabilizer. They may be the only pitch control surface present, and are sometimes located at the front of the aircraft (early airplanes and canards) or integrated into a rear "all-moving tailplane", also called a slab elevator or stabilator.
___Light_aircraft_q.jpg)
>>>PUT SHARE BUTTONS HERE<<<
In this Dossier
Elevator (aeronautics) in the context of Wright Flyer
The Wright Flyer (also known as the Kitty Hawk, Flyer I or the 1903 Flyer) made the first sustained flight by a manned heavier-than-air powered and controlled aircraft on December 17, 1903. Invented and flown by brothers Orville and Wilbur Wright, it marked the beginning of the pioneer era of aviation.
The aircraft is a single-place biplane design with anhedral (drooping) wings, front double elevator (a canard) and rear double rudder. It used a 12 horsepower (9 kilowatts) gasoline engine powering two pusher propellers. Employing "wing warping", it was relatively unstable and very difficult to fly.
Elevator (aeronautics) in the context of Vortex generator
A vortex generator (VG) is an aerodynamic device, consisting of a small vane usually attached to a lifting surface (or airfoil, such as an aircraft wing) or a rotor blade of a wind turbine. VGs may also be attached to some part of an aerodynamic vehicle such as an aircraft fuselage or a car. When the airfoil or the body is in motion relative to the air, the VG creates a vortex, which, by removing some part of the slow-moving boundary layer in contact with the airfoil surface, delays local flow separation and aerodynamic stalling, thereby improving the effectiveness of wings and control surfaces, such as flaps, elevators, ailerons, and rudders.
Elevator (aeronautics) in the context of Fly-by-wire
Fly-by-wire (FBW) is a system that replaces the conventional manual flight controls of an aircraft with an electronic interface. The movements of flight controls are converted to electronic signals, and flight control computers determine how to move the actuators at each control surface to provide the ordered response. Implementations either use mechanical flight control backup systems or else are fully electronic.
Improved fully fly-by-wire systems interpret the pilot's control inputs as a desired outcome and calculate the control surface positions required to achieve that outcome; this results in various combinations of rudder, elevator, aileron, flaps and engine controls in different situations using a closed feedback loop. The pilot may not be fully aware of all the control outputs acting to affect the outcome, only that the aircraft is reacting as expected. The fly-by-wire computers act to stabilize the aircraft and adjust the flying characteristics without the pilot's involvement, and to prevent the pilot from operating outside of the aircraft's safe performance envelope.
Elevator (aeronautics) in the context of Aircraft principal axes
An aircraft in flight is free to rotate in three dimensions: yaw, nose left or right about an axis running up and down; pitch, nose up or down about an axis running from wing to wing; and roll, rotation about an axis running from nose to tail. The axes are alternatively designated as vertical, lateral (or transverse), and longitudinal respectively. These axes move with the vehicle and rotate relative to the Earth along with the craft. These definitions were analogously applied to spacecraft when the first crewed spacecraft were designed in the late 1950s.
These rotations are produced by torques (or moments) about the principal axes. On an aircraft, these are intentionally produced by means of moving control surfaces, which vary the distribution of the net aerodynamic force about the vehicle's center of gravity. Elevators (moving flaps on the horizontal tail) produce pitch, a rudder on the vertical tail produces yaw, and ailerons (flaps on the wings that move in opposing directions) produce roll. On a spacecraft, the movements are usually produced by a reaction control system consisting of small rocket thrusters used to apply asymmetrical thrust on the vehicle.