Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts.
A stay is part of the standing rigging, (as opposed to a sheet (sailing), which is adjustable), and is used to hold a mast upright.
___Chainplate_q.jpg)
A chainplate is a metal plate used to fasten a shroud or stay to the hull of a sailboat to support the mast that sails are attached to. One end of the chainplate is normally fastened to a turnbuckle which is connected to the shroud or stay, whereas the remainder of the chainplate normally has multiple holes that are bolted to the hull, or the chains. This distributes the load across the hull, making it possible for a somewhat lighter hull to support the load of the shrouds and stays.Chainplates are commonly made from stainless steel or bronze. Stainless steel will corrode over time but bronze lasts the life of the yacht.
Rigging comprises the system of ropes, cables and chains, which support and control a sailing ship or sail boat's masts and sails. Standing rigging is the fixed rigging that supports masts including shrouds and stays. Running rigging is rigging which adjusts the position of the vessel's sails and spars including halyards, braces, sheets and vangs.
View the full Wikipedia page for RiggingA guy-wire, guy-line, guy-rope, down guy, or stay, also called simply a guy, is a tensioned cable designed to add stability to a freestanding structure. They are used commonly for ship masts, radio masts, wind turbines, utility poles, and tents. A thin vertical mast supported by guy wires is called a guyed mast. Structures that support antennas are frequently of a lattice construction and are called "towers". One end of the guy is attached to the structure, and the other is anchored to the ground at some distance from the mast or tower base. The tension in the diagonal guy-wire, combined with the compression and buckling strength of the structure, allows the structure to withstand lateral loads such as wind or the weight of cantilevered structures. They are installed radially, usually at equal angles about the structure, in trios and quads. As the tower leans a bit due to the wind force, the increased guy tension is resolved into a compression force in the tower or mast and a lateral force that resists the wind load. For example, antenna masts are often held up by three guy-wires at 120° angles. Structures with predictable lateral loads, such as electrical utility poles, may require only a single guy-wire to offset the lateral pull of the electrical wires at a spot where the wires change direction.
Conductive guy cables for radio antenna masts can catch and deflect radiation in unintended directions, so their electrical characteristics must be included in the design. Often the guy wire is divided by strain insulators into isolated sections whose lengths are not resonant with the transmission frequencies.
View the full Wikipedia page for Guy-wiresA staysail ("stays'l") is a fore-and-aft rigged sail whose luff can be affixed to a stay running forward (and most often but not always downwards) from a mast to the deck, the bowsprit, or to another mast.
View the full Wikipedia page for Staysail