Spar (sailing) in the context of "Foremast"

The crab claw sail is a fore-and-aft triangular sail with spars along upper and lower edges. The crab claw sail was first developed by the Austronesian peoples by at least 2000 BCE. It is sometimes known as the Oceanic lateen or the Oceanic sprit, even though it is not restricted to Oceania, is neither a lateen sail nor a spritsail, and has an independent older origin.

In sailing, a block is a single or multiple pulley. One or a number of sheaves are enclosed in an assembly between cheeks or chocks. In use, a block is fixed to the end of a line, to a spar, or to a surface. A line (rope) is reeved through the sheaves, and maybe through one or more matching blocks at some far end, to make up a tackle.

The purchase of a tackle refers to its mechanical advantage. In general the more sheaves in the blocks that make up a tackle, the higher its mechanical advantage. The matter is slightly complicated by the fact that every tackle has a working end where the final run of rope leaves the last sheave. More mechanical advantage can be obtained if this end is attached to the moving load rather than the fixed end of the tackle.

The mast of a sailing vessel is a tall spar, or arrangement of spars, erected vertically or near-vertically on the median line of a ship or boat. A mast may carry sails, spars, and derricks. It may also give necessary height to a navigation light, look-out position, signal yard, control position, radio aerial, or signal lamp. Large ships have several masts, with the size and configuration depending on the style of ship. Nearly all sailing masts are guyed.

Until the mid-19th century, all vessels' masts were made of wood, formed from one or several pieces of timber. This was typically the trunk of a single conifer tree; however, from the 16th century, vessels were often built too large for that. Larger vessels needed taller and thicker masts, which could not be made from single tree trunks. To achieve the required height, these masts were built from up to four sections (also called masts). From lowest to highest, these were called "lower", "top", "topgallant", and "royal" masts. For the lower sections to be thick enough, they needed to be built up from multiple pieces of wood. Such a section was known as a made mast, while a section formed from a single piece of timber was known as a pole mast.

In "Jackspeak" (Royal Navy slang), it also refers to the dress uniform of Junior Ratings.

The bowsprit of a sailing vessel is a spar extending forward from the vessel's prow. The bowsprit is typically held down by a bobstay that counteracts the forces from the forestays. The bowsprit’s purpose is to create anchor points for the sails that extend beyond the vessel’s bow, increasing the size of sail that may be held taut.

The word bowsprit is thought to originate from the Middle Low German word bōchsprēt – bōch meaning "bow" and sprēt meaning "pole".