Derrick in the context of "Science and technology of the Han dynasty"

The mast of a sailing vessel is a tall spar, or arrangement of spars, erected vertically or near-vertically on the median line of a ship or boat. A mast may carry sails, spars, and derricks. It may also give necessary height to a navigation light, look-out position, signal yard, control position, radio aerial, or signal lamp. Large ships have several masts, with the size and configuration depending on the style of ship. Nearly all sailing masts are guyed.

Until the mid-19th century, all vessels' masts were made of wood, formed from one or several pieces of timber. This was typically the trunk of a single conifer tree; however, from the 16th century, vessels were often built too large for that. Larger vessels needed taller and thicker masts, which could not be made from single tree trunks. To achieve the required height, these masts were built from up to four sections (also called masts). From lowest to highest, these were called "lower", "top", "topgallant", and "royal" masts. For the lower sections to be thick enough, they needed to be built up from multiple pieces of wood. Such a section was known as a made mast, while a section formed from a single piece of timber was known as a pole mast.

A drilling rig is an integrated system that drills wells, such as oil or water wells, or holes for piling and other construction purposes, into the earth's subsurface. Drilling rigs can be massive structures housing equipment used to drill water wells, oil wells, or natural gas extraction wells, or they can be small enough to be moved manually by one person and such are called augers. Drilling rigs can sample subsurface mineral deposits, test rock, soil and groundwater physical properties, and also can be used to install sub-surface fabrications, such as underground utilities, instrumentation, tunnels or wells. Drilling rigs can be mobile equipment mounted on trucks, tracks or trailers, or more permanent land or marine-based structures (such as oil platforms, commonly called 'offshore oil rigs' even if they don't contain a drilling rig). The term "rig" therefore generally refers to the complex equipment that is used to penetrate the surface of the Earth's crust.

Small to medium-sized drilling rigs are mobile, such as those used in mineral exploration drilling, blast-hole, water wells and environmental investigations. Larger rigs are capable of drilling through thousands of metres of the Earth's crust, using large "mud pumps" to circulate drilling fluid (slurry) through the bit and up the casing annulus, for cooling and removing the "cuttings" while a well is drilled. Hoists in the rig, a derrick, can lift hundreds of tons of pipe. Other equipment can force acid or sand into reservoirs to facilitate extraction of the oil or natural gas; and in remote locations there can be permanent living accommodation and catering for crews (which may be more than a hundred). Marine rigs may operate thousands of miles distant from the supply base with infrequent crew rotation or cycle.

A jib or jib arm is the horizontal or near-horizontal beam used in many types of crane to support the load clear of the main support. An archaic spelling is gib.

Usually jib arms are attached to a vertical mast or tower or sometimes to an inclined boom. In other jib-less designs such as derricks, the load is hung directly from a boom which is often anomalously called a jib.