Ablation zone in the context of "Snow line"

Play Trivia Questions online!

or

Skip to study material about Ablation zone in the context of "Snow line"




⭐ Core Definition: Ablation zone

Ablation zone or ablation area refers to the low-altitude area of a glacier or ice sheet below firn with a net loss in ice mass. This loss can result from melting, sublimation, evaporation, ice calving, aeolian processes like blowing snow, avalanche, and any other ablation. The equilibrium line altitude (ELA) or snow line separates the ablation zone from the higher-altitude accumulation zone. The ablation zone often contains meltwater features such as supraglacial lakes, englacial streams, and subglacial lakes. Sediments dropped in the ablation zone forming small mounds or hillocks are called kames. Kame and kettle hole topography is useful in identifying an ablation zone of a glacier. The seasonally melting glacier deposits much sediment at its fringes in the ablation area. Ablation constitutes a key part of the glacier mass balance.

The amount of snow and ice gained in the accumulation zone and the amount of snow and ice lost in the ablation zone determine glacier mass balance. Often mass balance measurements are made in the ablation zone using snow stakes.

↓ Menu

In this Dossier

Ablation zone in the context of Meltwater

Meltwater (or melt water) is water released by the melting of snow or ice, including glacial ice, tabular icebergs and ice shelves over oceans. Meltwater is often found during early spring when snow packs and frozen rivers melt with rising temperatures, and in the ablation zone of glaciers where the rate of snow cover is reducing. Meltwater can be produced during volcanic eruptions, in a similar way in which the more dangerous lahars form. It can also be produced by the heat generated by the flow itself.

When meltwater pools on the surface rather than flowing, it forms melt ponds. As the weather gets colder, meltwater will often re-freeze. Meltwater can also collect or melt under the ice's surface. These pools of water, known as subglacial lakes, can form due to geothermal heat and friction. Melt ponds may also form above and below Arctic sea ice, decreasing its albedo and causing the formation of thin underwater ice layers or false bottoms.

↑ Return to Menu

Ablation zone in the context of Glacier mass balance

Crucial to the survival of a glacier is its mass balance of which surface mass balance (SMB), the difference between accumulation and ablation (sublimation and melting). Climate change may cause variations in both temperature and snowfall, causing changes in the surface mass balance. Changes in mass balance control a glacier's long-term behavior and are the most sensitive climate indicators on a glacier. From 1980 to 2012 the mean cumulative mass loss of glaciers reporting mass balance to the World Glacier Monitoring Service is −16 m. This includes 23 consecutive years of negative mass balances.

A glacier with a sustained negative balance is out of equilibrium and will retreat, while one with a sustained positive balance is out of equilibrium and will advance. Glacier retreat results in the loss of the low elevation region of the glacier. Since higher elevations are cooler than lower ones, the disappearance of the lowest portion of the glacier reduces overall ablation, thereby increasing mass balance and potentially reestablishing equilibrium. However, if the mass balance of a significant portion of the accumulation zone of the glacier is negative, it is in disequilibrium with the local climate. Such a glacier will melt away with a continuation of this local climate.The key symptom of a glacier in disequilibrium is thinning along the entire length of the glacier. For example, Easton Glacier (pictured below) will likely shrink to half its size, but at a slowing rate of reduction, and stabilize at that size, despite the warmer temperature, over a few decades. However, the Grinnell Glacier (pictured below) will shrink at an increasing rate until it disappears. The difference is that the upper section of Easton Glacier remains healthy and snow-covered, while even the upper section of the Grinnell Glacier is bare, melting and has thinned. Small glaciers with shallow slopes such as Grinnell Glacier are most likely to fall into disequilibrium if there is a change in the local climate.

↑ Return to Menu

Ablation zone in the context of Accumulation zone

On a glacier, the accumulation zone is the area above the firn line, where snowfall accumulates and exceeds the losses from ablation, (melting, evaporation, and sublimation). The annual equilibrium line separates the accumulation and ablation zone annually. The accumulation zone is also defined as that part of a glacier's surface, usually at higher elevations, on which there is net accumulation of snow, which subsequently turns into firn and then glacier ice. Part of the glacier where snow builds up and turns to ice moves outward from there.

↑ Return to Menu

Ablation zone in the context of Ice calving

Ice calving, also known as glacier calving or iceberg calving, is the breaking of ice chunks from the edge of a glacier. It is a form of ice ablation or ice disruption. It is the sudden release and breaking away of a mass of ice from a glacier, iceberg, ice front, ice shelf, or crevasse. The ice that breaks away can be classified as an iceberg, but may also be a growler, bergy bit, or a crevasse wall breakaway.

Calving of glaciers is often accompanied by a loud cracking or booming sound before blocks of ice up to 60 metres (200 ft) high break loose and crash into the water. The entry of the ice into the water causes large, and often hazardous waves. The waves formed in locations like Johns Hopkins Glacier can be so large that boats cannot approach closer than three kilometres (1+12 nautical miles). These events have become major tourist attractions in locations such as Alaska.

↑ Return to Menu

Ablation zone in the context of Glacier terminus

A glacier terminus, toe, or snout, is the end of a glacier at any given point in time. Although glaciers seem motionless to the observer, in reality they are in endless motion and the glacier terminus is always either advancing or retreating. The location of the terminus is often directly related to glacier mass balance, which is based on the amount of snowfall which occurs in the accumulation zone of a glacier, as compared to the amount that is melted in the ablation zone. The position of a glacier terminus is also impacted by localized or regional temperature change over time.

↑ Return to Menu

Ablation zone in the context of Glacier ice accumulation

Glacier ice accumulation occurs through accumulation of snow and other frozen precipitation, as well as through other means including rime ice (freezing of water vapor on the glacier surface), avalanching from hanging glaciers on cliffs and mountainsides above, and re-freezing of glacier meltwater as superimposed ice. Accumulation is one element in the glacier mass balance formula, with ablation counteracting. With successive years in which accumulation exceeds ablation, then a glacier will experience positive mass balance, and its terminus will advance.

↑ Return to Menu