Recirculating ball, also known as recirculating ball and nut or worm and sector, is a ball screw steering mechanism commonly found in older automobiles, off-road vehicles, and some trucks. Most newer cars use the more economical rack and pinion steering instead, but some upmarket manufacturers (such as BMW and Mercedes-Benz) held on to the design until well into the 1990s for the durability and strength inherent in the design. A few, including Chrysler, General Motors, Lada and Ineos, still use this technology in certain models including the Jeep Wrangler, the Ineos Grenadier Quartermaster and the Lada Niva.
HINT:
In this Dossier
Recirculating ball in the context of Steering wheel
A steering wheel (also called a driving wheel, a hand wheel, or simply wheel) is a type of steering control in vehicles.
Steering wheels are used in most modern land vehicles, including all mass-production automobiles, buses, light and heavy trucks, as well as tractors and tanks. The steering wheel is the part of the steering system that the driver manipulates; the rest of the steering system responds to such driver inputs. This can be through direct mechanical contact as in recirculating ball or rack and pinion steering gears, without or with the assistance of hydraulic power steering, HPS, or as in some modern production cars with the help of computer-controlled motors, known as electric power steering.
View the full Wikipedia page for Steering wheelRecirculating ball in the context of Ball screw
A ball screw (or ballscrew) is a mechanical linear actuator that translates rotational motion to linear motion with little friction. A threaded shaft provides a helical raceway for ball bearings which act as a precision screw. As well as being able to apply or withstand high thrust loads, they can do so with minimum internal friction. They are made to close tolerances and are therefore suitable for high-precision applications. The ball assembly acts as the nut while the threaded shaft is the screw.
In contrast to conventional leadscrews, ball screws tend to be rather bulky, due to the need to have a mechanism to recirculate the balls.
View the full Wikipedia page for Ball screw