Data transmission in the context of "Microwave relay"

In telecommunications, broadband or high speed is the wide-bandwidth data transmission that uses signals at a wide spread of frequencies or several different simultaneous frequencies. It is used in fast Internet access where the transmission medium can be coaxial cable, optical fiber, wireless Internet (radio), twisted pair cable, or satellite.

Originally used to mean "using a wide-spread frequency" and for services that were analog at the lowest level, in the context of Internet access, "broadband" is now often used to mean any high-speed Internet access that is seemingly always "on" and is faster than dial-up access over traditional analog or ISDN PSTN services.

In information theory, data compression, source coding, or bit-rate reduction is the process of encoding information using fewer bits than the original representation. Any particular compression is either lossy or lossless. Lossless compression reduces bits by identifying and eliminating statistical redundancy. No information is lost in lossless compression. Lossy compression reduces bits by removing unnecessary or less important information. Typically, a device that performs data compression is referred to as an encoder, and one that performs the reversal of the process (decompression) as a decoder.

The process of reducing the size of a data file is often referred to as data compression. In the context of data transmission, it is called source coding: encoding is done at the source of the data before it is stored or transmitted. Source coding should not be confused with channel coding, for error detection and correction or line coding, the means for mapping data onto a signal.

In telecommunications, information transfer is the process of moving messages containing user information from a source to a sink via a communication channel. In this sense, information transfer is equivalent to data transmission which highlights more practical, technical aspects.

The information transfer rate may or may not be equal to the transmission modulation rate.

Microwave transmission is the transmission of information by electromagnetic waves with wavelengths in the microwave frequency range of 300 MHz to 300 GHz (1 m - 1 mm wavelength) of the electromagnetic spectrum. Microwave signals are normally limited to the line of sight, so long-distance transmission using these signals requires a series of repeaters forming a microwave relay network. It is possible to use microwave signals in over-the-horizon communications using tropospheric scatter, but such systems are expensive and generally used only in specialist roles.

Although an experimental 40-mile (64 km) microwave telecommunication link across the English Channel was demonstrated in 1931, the development of radar in World War II provided the technology for practical exploitation of microwave communication. During the war, the British Army introduced the Wireless Set No. 10, which used microwave relays to multiplex eight telephone channels over long distances. A link across the English Channel allowed General Bernard Montgomery to remain in continual contact with his group headquarters in London.

File sharing is the practice of distributing or providing access to digital media, such as computer programs, multimedia (audio, images and video), documents or electronic books. Common methods of storage, transmission and dispersion include removable media, centralized servers on computer networks, Internet-based hyperlinked documents, and the use of distributed peer-to-peer networking.

File sharing technologies, such as BitTorrent, are integral to modern media piracy, as well as the sharing of scientific data and other free content.

Information assurance (IA) is the practice of assuring information and managing risks related to the use, processing, storage, and transmission of information. Information assurance includes protection of the integrity, availability, authenticity, non-repudiation and confidentiality of user data. IA encompasses both digital protections and physical techniques. These methods apply to data in transit, both physical and electronic forms, as well as data at rest. IA is best thought of as a superset of information security (i.e. umbrella term), and as the business outcome of information risk management.

A sequence of events is isochronous if the events occur regularly, or at equal time intervals. The term isochronous is used in several technical contexts, but usually refers to the primary subject maintaining a constant period or interval (the reciprocal of frequency), despite variations in other measurable factors in the same system. Isochronous timing is a characteristic of a repeating event, whereas synchronous timing refers to the relationship between two or more events.

• In dynamical systems theory, an oscillator is called isochronous if its frequency is independent of its amplitude.
• In horology, a mechanical clock or watch is isochronous if it runs at the same rate regardless of changes in its drive force, so that it keeps correct time as its mainspring unwinds or chain length varies. Isochrony is important in timekeeping devices. Simply put, if a power-providing device (e.g. a spring or weight) provides constant torque to the wheel train, it will be isochronous, since the escapement will experience the same force regardless of how far the weight has dropped or the spring has unwound.
• In electrical power generation, isochronous means that the frequency of the electricity generated is constant under varying load; there is zero generator droop. (See Synchronization (alternating current).)
• In telecommunications, an isochronous signal is one where the time interval separating any two corresponding transitions is equal to the unit interval or to a multiple of the unit interval; but phase is arbitrary and potentially varying.
  • The term is also used in data transmission to describe cases in which corresponding significant instants of two or more sequential signals have a constant phase relationship.
  • Isochronous burst transmission is used when the information-bearer channel rate is higher than the input data signaling rate.
• In the Universal Serial Bus used in computers, isochronous is one of the four data flow types for USB devices (the others being Control, Interrupt and Bulk). It is commonly used for streaming data types such as video or audio sources. Similarly, the IEEE 1394 interface standard, commonly called Firewire, includes support for isochronous streams of audio and video at known constant rates.
• In particle accelerators an isochronous cyclotron is a cyclotron where the field strength increases with radius to compensate for the relativistic increase in mass with speed.
• An isochrone is a contour line of equal time, for instance, in geological layers, tree rings or wave fronts. An isochrone map or diagram shows such contours.
• In linguistics, isochrony is the postulated rhythmic division of time into equal portions by a language.
• In neurology, isochronic tones are regular beats of a single tone used for brainwave entrainment.

Telemetry is the in situ collection of measurements or other data at remote points and their automatic transmission to receiving equipment (telecommunication) for monitoring. The word is derived from the Greek roots tele, 'far off', and metron, 'measure'. Systems that need external instructions and data to operate require the counterpart of telemetry: telecommand.

Although the term commonly refers to wireless data transfer mechanisms (e.g., using radio, ultrasonic, or infrared systems), it also encompasses data transferred over other media such as a telephone or computer network, optical link or other wired communications like power line carriers. Many modern telemetry systems take advantage of the low cost and ubiquity of GSM networks by using SMS to receive and transmit telemetry data.

A personal area network (PAN) is a computer network for interconnecting electronic devices within an individual person's workspace. A PAN provides data transmission among devices such as computers, smartphones, tablets and personal digital assistants. PANs can be used for communication among the personal devices themselves, or for connecting to a higher level network and the Internet where one master device takes up the role as gateway.

A PAN may be carried over wired interfaces such as USB, but is predominantly carried wirelessly, also called a wireless personal area network (WPAN). A PAN is wirelessly carried over a low-powered, short-distance wireless network technology such as IrDA, Wireless USB, Bluetooth, NearLink or Zigbee. The reach of a WPAN varies from a few centimeters to a few meters. WPANs specifically tailored for low-power operation of the sensors are sometimes also called low-power personal area network (LPPAN) to better distinguish them from low-power wide-area network (LPWAN).