Data terminal equipment in the context of Network nodes

Networking hardware, also known as network equipment or computer networking devices, are electronic devices that are required for communication and interaction between devices on a computer network. Specifically, they mediate data transmission in a computer network. Units which are the last receiver or generate data are called hosts, end systems or data terminal equipment.

In networking, a node (Latin: nodus, 'knot') is either a redistribution point or a communication endpoint within telecommunication networks or computer networks.

A physical network node is an electronic device that is attached to a network, and is capable of creating, receiving, or transmitting information over a communication channel. In data communication, a physical network node may either be data communication equipment (such as a modem, hub, bridge or switch) or data terminal equipment (such as a digital telephone handset, a printer or a host computer).

A data link is a means of connecting one location to another for the purpose of transmitting and receiving digital information (data communication). It can also refer to a set of electronics assemblies, consisting of a transmitter and a receiver (two pieces of data terminal equipment) and the interconnecting data telecommunication circuit. These are governed by a link protocol enabling digital data to be transferred from a data source to a data sink.

In the context of telecommunications, a terminal is a device which ends a telecommunications link and is the point at which a signal enters or leaves a network. Examples of terminal equipment include telephones, fax machines, computer terminals, printers and workstations.

An end instrument is a piece of equipment connected to the wires at the end of a telecommunications link. In telephony, this is usually a telephone connected to a local loop. End instruments that relate to data terminal equipment include printers, computers, barcode readers, automated teller machines (ATMs) and the console ports of routers.

Isochronous burst transmission is a method of transmission. In a data network where the information-bearer channel rate is higher than the input data signaling rate, transmission is performed by interrupting, at controlled intervals, the data stream being transmitted.

Note 1: Burst transmission in isochronous form enables communication between data terminal equipment (DTE) and data networks that operate at dissimilar data signaling rates, such as when the information-bearer channel rate is higher than the DTE output data signaling rate.

A serial cable or RS-232 cable is a cable used to transfer information between two devices using a serial communication protocol. The form of connectors depends on the particular serial port used. A cable wired for connecting two DTEs directly is known as a null modem cable.

A data circuit-terminating equipment (DCE) is a device that sits between the data terminal equipment (DTE) and a data transmission circuit. It is also called data communication(s) equipment and data carrier equipment. Usually, the DTE device is the terminal (or computer), and the DCE is a modem.

In a data station, the DCE performs functions such as signal conversion, coding, and line clocking and may be a part of the DTE or intermediate equipment. Interfacing equipment may be required to couple the DTE into a transmission circuit or channel and from a transmission circuit or channel into the DTE.